STOP Clinical Skin Renewal Device - in Black

Before first use, read enclosed User Instructions and watch instructional DVD.

The aim of the treatment is to heat the skin from within throughout the entire treatment area and then maintain the temperature for a few minutes. During treatment you will simply move the STOP device evenly and slowly over your face, maintaining the four pole electrodes in constant contact with the skin.

Please note that you must always spread the STOP preparation gel on the treated area prior to commencing the treatment!

Spread the preparation gel on your face, set your preferred treatment level (low - medium - high) and turn the STOP device on.

Warming Up Stage

In the first stage of the treatment you will warm up your skin by moving the STOP over different parts of your face in slow circular motion. You should warm up the skin on your entire face, moving from one area to the adjacent area until you cover your entire face. The STOP device will indicate, when the skin on the area worked on is suitably warmed up and you should move to the adjacent area.

The Warming Up Stage takes approximately 5 minutes.

Maintaining Heat Level Stage

The effectiveness of the treatment depends on the heat level being maintained over a period of time. Once you have completed the Warming Up of the entire face, you should commence on maintaining of the temperature.

You will achieve this by simply continuing to move the STOP device freely over the entire face in small circular or elliptical motion. This will ensure uniformity of the heat and temperature. You also can augment the treatment by performing 'lifting' movements from the jowl line upwards towards the cheeks.

The Maintaining Heat Level Stage takes approximately 7 - 10 minutes. At the end of this stage, the safety mechanism on the STOP device will turn the green light on the device off to indicate to you that you have achieved the optimum heating and optimum time required and you should end the treatment. At this point, cease the treatment and turn the device off.

After treatment, you should remove the residue of the STOP Skin Preparation Gel and moisturize your face with the STOP After Treatment Cream. For best results, you should always follow the Stop treatment with an application of the Stop After Treatment Cream. Use of other creams may significantly reduce the effects of the treatment.

The complete STOP treatment session should have lasted between 12 - 15 minutes.

STOP Precautions

You should not use the Stop device is any of the following applies to you:

" Have a pacemaker fitted

" Have internal defibrillator

" Have metal implants in the treatment area (i.e. gold threads). Please note that dental fillings or dental implants do not present a problem!

" Current or history of cancer, especially skin cancer or pre-malignant moles

" Severe conditions, such as cardiac disorders

" You are pregnant or nursing

" Your immune system is impaired due to immunosuppressive diseases, such as AIDS

" If you are using immunosuppressive medications

" If you suffer diseases or conditions stimulated by heat, such as recurrent Herpes Simplex in the treatment area

" Suffer any active skin conditions in the treatment area, such as psoriasis, eczema or rash

" Have a history of keloid scarring, abnormal wound healing or fragile skin

" Had a surgical procedure, laser resurfacing or deep chemical peel in the treatment area in the last 3 months or still undergoing a process of complete healing

" If you have permanent fillers in the treatment area

" Consult your doctor before the start of the treatment, if you have temporary dermal fillers in the treatment area

" If you use medications, herbal preparations, vitamins or food supplements that may cause fragile or dry skin

" If you are in any doubt in respect of other aesthetic procedures, consult your doctor prior to using STOP

" Under age of 18 years